ProStar™ Hydraulic Roll Bender - PRSRH55

Bend up to Four-Inch Round Tubing and up to Five-Inch Flat Bar

Linde’s ProStar™ PRSRH55 tube and angle roller is made for roll bending round tubing and pipe, sections, bar and angle iron. This machine incorporates three inverter-driven rolls, each one powered by a direct-drive transmission for increased power and overload protection.

The unit ships standard with a set of segment rolls, lateral roll guides for coiling and operator-friendly control station.

Three Power-Driven Rolls

  • Bend up to 4 in. round tubing with a .083 in. wall
  • Hydraulic top roll positioning
  • Horizontal or vertical bending
  • Digital readout
  • 220 V 3-phase
Praxair Hydraulic Roll Bender PRSRH55

Standard Configuration

Part No.PipeRound TubeSquare TubeAngle IronSolid Square Solid RoundFlat Bar Easy WayFlat Bar Hard WayRoll AdjustmentPinch Shaft DiameterRoll Diameter UpperRoll Diameter LowerShaft Center Distance (lower rolls)Driven RollsSpeed (variable)MotorPower RequirementsDimensions (L/W/H)Shipping Weight
PRSRH552.5in. (sch. 40)/40 in.  4 in. (.083 in.)/72 in. 2.75 in. (.083 in.)/54 in. 3 in. (.250 in.) /36 in.1.75 in. / 28 in. 2 in. / 28 in.5 in. (.75 in.) / 28 in.3.5 in. (.675 in.) / 32 in.HydraulicSingle2.165 in.6.693 in.6.693 in.11.875 in.311 rpm5 hp22 V 3-ph60 in. x 44 in. x 68 in.1,728 lbs.

All specs based on 60,000 psi (42 kg/mm2) tensile strength mild steel. Specifications subject to change without notice.